Products

Self-Drilling Anchors

The self-drilling Hollow bar anchor system is comprised of a hollow threaded bar with an attached drill bit that can perform drilling, anchoring and grouting in a single operation. The hollow bar allows air and water to freely pass through the bar during drilling to remove debris and then allow grout to be injected immediately after drilling is completed. Grout fills the hollow bar and completely covers the entire bolt. Couplers can be used to join hollow bars and extend the bolt length while nuts and plates are used to provide the required tension.

Panchvaktram Engineering offers Self Drilling Anchors in variants of R25, R32, R38, R51 and T76 and their accessories including the Anchor Nut, Anchor Plate, Anchor Coupler and Drilling bits depending on the geological condition of the project site (Type EX, EXX, ES, ESS, EY, EYY)

Anchor Rods

Unit R 25N R32L R32N R32S R38 N R 51L R 51N T 76N T 76S
Outer Diameter mm 25.00 32.00 32.00 32.00 38.00 51.00 51.00 76.00 76.00
Inner Diameter mm 14.00 22 21 17.00 21.00 38.00 33.00 51.00 47.00
Ultimate Load kN 200 260 280 360 500 550 800 1600 1900
Yield Load kN 150 200 230 280 400 450 630 1200 1500
 

Anchor Nuts

Unit R 25N R32L R32N R32S R38 N R 51L R 51N T 76N T 76S
Key Size mm 41 46 46 46 50 75 75 100 100
Length mm 35 45 45 65 60 70 70 80 80
 

Anchor Plate

Unit R 25N R32L R32N R32S R38 N R 51L R 51N T 76N T 76S
Dimension mm 150x150 200x200 200x200 200x200 200x200 200x200 250x250 250x250 250x250
Thickness mm 8 10 10 12 12 30 40 40 40
Hole Diameter mm 30 35 35 35 41 60 60 80 80
 

Anchor Coupler

Unit R 25N R32L R32N R32S R38 N R 51L R 51N T 76N T 76S
Outer Diameter mm 36 42 42 42 52 63 63 95 95
Length mm 150 145 160 190 220 140 200 200 220